Point worked until the ceiling was worked on
A cable damaged or unplugged by another trade above the tiles. Common after any HVAC, lighting or sprinkler work, and quick to find once somebody looks up.
Security & Low Voltage4,401 businesses licensed for it
Network cabling and data point repair
This is the physical layer only: the cable, the outlet, the patch panel and the switch position. Work covers testing and replacing failed data points, tracing damaged runs, terminating and certifying new cabling, structured cabling for a fit-out, and power over ethernet for cameras, access control and wireless points. It is not internet support: if the line is down, that is your provider, and no contractor can fix their outage.
Enter your ZIP to see the businesses listed for this trade nearest to your site, with their phone numbers.
- Free to searchno account, nothing to submit
- Public registersevery listing names its source
- License numberswhere the state publishes one
- Directyou call the business yourself
- Our estimate
- $200-$9,000
- Time on site
- 1.5-16 hrs
- Fault patterns covered
- 2
- Licensed for this trade itself
- 4,401
What network cabling and data point repair costs
Most of these jobs land near $620. The full spread runs $200 to $9,000, and the gap between those two ends is diagnosis against replacement rather than one business being dearer than another.
What moves it: how much of the job is parts, whether the fault is found in the first hour or the third, access to the equipment, and the hour of the day you call. We never speak to the businesses listed here, so there is no rate card behind any of this. It is our own band for the category, and there is no regional index: the figure does not change with your metro.
| How soon you need it | Typical | Range |
|---|---|---|
| Scheduled visitBooked in advance, no urgency multiplier applied | $620 | $200 to $9,000 |
| Same dayOur band multiplied by 1.12 | $695 | $225 to $10,080 |
| Emergency calloutOur band multiplied by 1.35 | $835 | $270 to $12,150 |
Our estimate from national cost bands, not a quote from any business. Every row is the same band with the urgency multiplier the site applies everywhere else, so this table can never contradict the headline number. Ask for a written price before the work starts.
Who is licensed to do this work
In California the classification that squarely covers this is C-7 low voltage systems, and the register says who holds it. Every listing on this site shows the classification, the license number and the date we read it, with a link back to the register entry so you can check it against the state rather than against us.
Overlapping classifications exist and are labeled as overlapping rather than as a match: C-10 electrical and C-28 lock and security equipment. A general building contractor may hold the job and subcontract the trade, which is a real answer and a different one, so the card says which of the two you are looking at.
One thing worth being plain about: CSLB classifications do not distinguish commercial work from residential. There is no separate commercial license to hold and no register field that would prove one. That is why this page describes the equipment rather than the contractor, and why nothing here says a business has been checked out. We read a public record on a stated date. That is the whole claim.
Before you pay for a callout
Two minutes of checks that sometimes end the problem
We would rather you did not need a callout at all. These are the checks that end the most calls for this fault.
Try a quick fix first
Some issues resolve without a truck roll. Two minutes now can save the callout.
- 1
Establish whether the internet is down or one point is down. If nothing works anywhere, that is your provider's outage and a cabling contractor cannot help.
- 2
Try a different cable and a different port on the switch first. A patch lead is the most common failure in the whole chain and it costs nothing to swap.
- 3
Count the points you need before a fit-out and add spares. Pulling cable during a fit-out is cheap and pulling it afterwards through a finished ceiling is not.
- 4
Ask for certification test results on any new cabling. A cable that looks terminated and fails at speed is invisible until it is causing problems.
What the visit actually includes
- Point-by-point testing to find the failed run
- Re-termination or replacement of damaged cable
- New runs installed and labeled at both ends
- Patch panel and cabinet reorganization
- Certification results for new cabling
Diagnosis
How network cabling faults usually present
Written from how these faults actually present on a working premises, not from a manual.
Camera or access point drops out repeatedly
Power over ethernet at the limit, either cable length or a switch that cannot supply the budget. It looks like a device fault and it is an infrastructure one.
Listed for this trade
Businesses listed for network cabling
Read from public license registers, so there is no ranking here and no distance: this page has no location to measure from. Enter your ZIP to sort by who is nearest to your site.
By location
Network cabling and data point repair near you
Local pages show which businesses are listed for that metro, how far out they sit, and the local conditions that drive demand.
Counted from the businesses we have imported for each metro center inside a 25 mile radius, and counting only those whose own license classification names this trade. General contractors licensed widely enough to take it on and subcontract it are excluded here, and still appear in a search. A metro reads “none yet” until we load a register that covers this trade there.
All coverage areasQuestions owners ask
Network cabling FAQs
Short, specific answers. If yours is not here, ask the business you call before you agree to the visit.
Is my internet outage this service?
No. A provider outage or a failed router is between you and your internet company, and it is usually free to have them fix. This service is the cabling inside the building.
Do I need licensed cabling installers?
C-7 low voltage systems is the California classification, and it is what the businesses listed here hold. Structured cabling in a commercial building is genuinely worth having done by someone who certifies the runs.
Cabling or wireless for a new fit-out?
Cable anything fixed: tills, printers, cameras, access points. Wireless for what moves. Wireless access points still need a cable and power, which is why fit-outs need both.
Related work
Often booked in the same visit
Batching jobs into one mobilization is the cheapest way to buy this kind of work.
CamerasCameras offline, no recording, dark night images and recorders that lost the drive.from $200AlarmFalse alarms, panels that will not set, dead sensors and monitoring that stopped.from $180Access controlFailed readers, keypads, maglocks, intercoms and staff cards that stopped working.from $220Walk-in coolerCooler not holding temperature, iced coils, failed compressors and door seals.from $260
Security & Low Voltage
Everything else in security & low voltage
Read next
When the POS goes down: a 20 minute triage order
Keep selling first, then work the failure in the order that avoids rebooting the whole network twice.
6 min read
CCTV that actually holds up after an incident
Retention, pixel density, clock sync and one three-minute monthly test that tells you whether your footage is usable.
6 min read
How to check a California contractor license before you hire
Three minutes on the state's own lookup, what the result does and does not prove, and the two questions to ask on the phone.
7 min read
Ready when you are
Need network cabling sorted?
Search your ZIP to see the businesses listed for this trade nearest to your site, with the license numbers and phone numbers we hold, then call them yourself.
- Cost to search
- Free
- Account needed
- None
- Who you call
- The business