Skip to main content
Free to use, no account needed
Fixadore
Find local trades
Near me

Commercial repair trades near me

There is no such thing as a national near-me answer, so here is the honest version. Near means a radius measured from the ZIP you type in. Enter the ZIP of your premises and you get the businesses inside that radius, sorted by distance and shown with an estimated drive time, and anything outside it is left out rather than padded in.

Use the ZIP of the premises, not the office ZIP. Search starts at 25 miles and steps out to 75 if the first ring comes back thin.

  • Free to searchno account, nothing to submit
  • Public registersevery listing names its source
  • License numberswhere the state publishes one
  • Directyou call the business yourself

By trade

The near-me searches owners actually run

Pick the trade and you get the same radius, applied to the businesses licensed for that specific work. Prices shown are the national band for the job, which is our own estimate rather than anybody's quote.

All services
Walk-in cooler near meCooler not holding temperature, iced coils, failed compressors and door seals.$260 to $3,400Water heater near meNo hot water, lukewarm supply, leaking tanks, pilot faults and tankless error codes.$220 to $4,800Commercial drain near meSlow and backed-up sinks, floor drains, toilets and the line under the kitchen.$180 to $2,200Rooftop HVAC near meRTU not cooling or heating, tripping breakers, noisy fans and belt failures.$260 to $4,200Commercial AC near meWarm air from the vents, weak airflow, condensate leaks and thermostat faults.$190 to $2,800Power loss near mePart of the premises dead, breakers that will not stay in, and no power at all.$200 to $3,200Commercial heating near meNo heat, short cycling, ignition lockouts and unit heater failures.$210 to $3,100Reach-in cooler near meWarm doors, fogged glass, broken hinges, failed fans and cooler lighting.$180 to $1,450

Also searched near me

Other trades with their own near-me page

Read the result properly

How to tell whether a business is actually near you

The number of miles on the card is not the number that decides your morning. This is worth two minutes before you start calling round.

1

Convert miles into drive time before you plan the day

Straight-line distance understates real travel, and it understates it worst at short range where lights and street grids dominate. Three miles across a dense metro is about 11 minutes with load-out, which is over 3.7 minutes per mile, while 40 miles of highway runs closer to 1.3. So the nearest pin is not always the earliest arrival.

2

Ask what the travel costs before the truck rolls

A business working the outer edge of a 75 mile ring absorbs roughly 94 minutes of driving each way. That time gets priced somewhere, either in a callout fee, in a minimum-hours charge, or in how long you wait. Ask on the phone: we do not hold anyone's rates, so the only place that number exists is the call.

What the estimate is built from

Drive time is a piecewise average speed by distance band plus a fixed four minute load-out, not a routing subscription. It is deliberately conservative at short range. Treat it as the number to plan against and confirm a real ETA on the phone.

Coverage

Metros with their own page

Each metro page carries the businesses listed for that area and the register every listing came from. A search from a ZIP inside the metro will also reach businesses based outside it, because the ring is drawn around you rather than around the city line.

Browse by state

By state

State hubs, with the local conditions that break equipment

One ZIP, real answers

See who is actually near your premises

Search the ZIP of the premises and get the businesses inside your radius, nearest first, with the phone number to call.

Cost to search
Free
Account needed
None
Who you call
The business
Find local tradesBrowse services